 When
OKK Europe GmbH wanted a pre-hardened steel to demonstrate the
accuracy, sensitivity and speed of its new range of VP Machining
Centres they naturally chose NAK 80 from Carrs Toolsteel
Technologies as the ideal material.
"NAK 80 is a good example of a new technology
toolsteel" says Bill Church, Carrs Managing Director "at
40 HRC it is readily machinable and highly polishable, it is a
remarkable steel. It never ceases to surprise me that people
invest in the latest machining technology such as the OKK range
and then expect the best results using a standard commercial tool
steel such as P20 that has been around for over 50 years. For the
best results the steel should complement the technology of the VP
Machining Centre and NAK 80 and OKK are just that winning
combination."
 |
